Stone Saw Track

Click To Add This Page To Your Favorites                                 1-866-377-8665 10:00 AM - 6:00 PM EST.

                                          DRP Enterprise Inc.

Felker Track Master® III Track Saw

Check-Out

Improved Drive System. A variable speed drive motor powers the stone track saw, allowing perfectly straight cuts and reducing error. A cooling fan increases life expectancy of all electrical components and reduce condensation. The air filter of the cooling fan prevents dust from entering the drive box. Fixed voltage circuitry prevents the motor to overheat if temporarily stalled. Resistors on the circuit board are siliconed into place.

Drive and Speed Control The speed control on the drive motor allows the operator to adjust speed to match material hardness. The improved Track Master III utilizes a new cam design which adjusts rollers more efficiently, eliminating cam seizing due to electrolysis. The cams are now stronger and the bottom four rollers are machined to accommodate built-in shims on the backside for straighter cuts. The drive chain is now stronger and heavier -- increased to U.S. #35. This reduces stretching so there is little or no needfor chain adjustment.

Built-In Safety With the drive motor clutch engaged and motor off, the clutch acts as a brake, preventing the saw from moving on the rail system. This is ideal for transportation. Disengaging the clutch allows for manual operation of the saw. The on / off power switch is triple sealed for safety.

Saw Never Touches Material The vibration-free Track Master III rail system holds the saw 1/4" off the slab, reducing the risk of damage to the material. A suspended system also permits slab cuts, either vertical or horizontal. The built-in, maintenance-free rollers on which the saw bracket rides are self-lubricating, no need for grease or oil. Depth of cut is adjustable with the convenient lever at the back of the saw. The width of cut can be as small as 1/4".

Expanding the System
Add vacuum cups and track to fit your job requirements, with lengths ranging from 2 ft. to 12 ft. The precision aluminum rails are designed with slip-on rail shoes to protect the material surface and rails from scratches.

The Vacuum Advantage
No clamps are needed. It produces grinding and polishing results with no variance at the outside edge. It minimizes the need for grout. It reduces the time consuming process of aligning grout lines and leveling uneven slabs.

Tile & Stone InstallerSave time and money by installing multiple rows of material, with flush and level surfaces. With the Track Master III, install a 2' x 7' countertop of (14) 12" x 12" tiles in minutes. Use accelerated setting materials without fear of material drying before the tile is in place. Slab cutouts are faster, safer and easier. Even a full slab can be cut on edge, with proper back-up clamps.

Multi-Module Package Track Master III comes complete with four 7 ft. sections of track, vacuum pump, four 3"x10" vacuum cup assemblies, worm drive motor, Bosch 17 amp® 7-1/4"  saw, 25 ft. of vacuum and water hose, 25 ft. extension cord, saw and router bracket, connector and gauge plates, and stainless steel hardware (additional components sold separately).

Place Your Order Toll Free 1-866-377-8665

DRP Inc. 6401 E. Rogers Cir. #2, Boca Raton Fl. 33487

Mail To: Tile Tool Information