|
| |
Check-Out
Target Guardmatic Masonry Saw
are the best
heavy duty masonry saw on the market. Looking for masonry saw? Target was the pioneer
of mason saws. Target masonry saws are for brick, block, pavers, and mason
products. Target's Porta line of masonry saws range from heavy duty 3 horsepower
electric or 13 horsepower gas models. See Parts Bottom Of Page.
|
Target
Guardmatic ® 14" Masonry Saws
| Engine Manufacturer |
Baldor |
| Engine Spec |
T.E.F.C. |
| Horsepower |
3 - 5 HP |
| Starter |
Capacitor |
| Voltage |
208230V |
| Phases |
1 |
| Cycles |
60/AC/1HZ |
| Full Load |
14.5A/13A |
| Starting |
188/95A |
| Blade Shaft RPM |
3090 |
| Blade Capacity |
14" - 20" |
| Max Depth of Cut |
5" |
| Arbor Size |
1" |
| Blade Shaft Bearings |
Ball Bearings |
| Blade Shaft Drive |
2V-Belts |
|
Target Guardmatic ® 14" Masonry Saws
Dual capacitor increases power efficiency and reduces run amperage,
making it an ideal machine for low voltage conditions. Electric motors
operate on a run and start capacitor. Cutting head pivot on bearings
which are sealed and lubricated for life - no greasing required!
Bearings are seated in a machined saddle, on a heavy-duty support, for
precise alignment that lasts.
Cutting head height can be controlled with a convenient crank control
and foot pedal.
Check-Out |
|
Target
Guardmatic ® 20" Masonry Saws
| Engine Manufacturer |
Baldor |
| Engine Spec |
T.E.F.C. |
| Horsepower |
3 - 5 HP |
| Starter |
Capacitor |
| Voltage |
208230V |
| Phases |
1 |
| Cycles |
60/AC/1HZ |
| Full Load |
14.5A/13A |
| Starting |
188/95A |
| Blade Shaft RPM |
3090 |
| Blade Capacity |
14" - 20" |
| Max Depth of Cut |
8" |
| Arbor Size |
1" |
| Blade Shaft Bearings |
Ball Bearings |
| Blade Shaft Drive |
2V-Belts |
|
Target Guardmatic ® 20" Masonry Saws
Dual capacitor increases power efficiency and reduces run amperage,
making it an ideal machine for low voltage conditions. Electric motors
operate on a run and start capacitor. Cutting head pivot on bearings
which are sealed and lubricated for life - no greasing required!
Bearings are seated in a machined saddle, on a heavy-duty support, for
precise alignment that lasts.
Cutting head height can be controlled with a convenient crank control
and foot pedal.
Check-Out |
 |
DRP
Enterprise Inc.
Serving the Tile, Stone, Carpet, Swimming Pool and Flooring
Industries for 20 years. |
|
